*How to identify 028D8 location value on the EEPROM programmer
CALCULATION OF THE NEW VALUE OF THE LOCATION
Seleziona lingua:
SEPDISP21B
Modification for Mercedes SLK R171 display
WARNING: This process is recommended only to expert and qualified staff.
Before installing the new SEPDISP21B display, please read carefully the following instructions.
DON’T SKIP ANY STEP.
THE FOLLOWING MODIFICATION IS NECESSARY FOR THE CORRECT FUNCTIONING OF SEPDISP21B DISPLAY (pic. 1).
Replace the display in an ambient temperature of 25 °C
To adjust SEPDISP21B display voltage:
After replacing the LCD, switch on the cluster: white connector (pic. 2) pin no. 1 negative, pin no. 5 and pin no. 6 positive.
Measure the voltage between A and B points as in picture 3.
· If the voltage measured is between 11.98V and 12.02V, no modification is necessary;
· If the voltage detected is instead lower than 11.98V or higher than 12.02V, it is necessary to do the modification described in the
following paragraph “MODIFICA EEPROM”.
Measuring display voltage
EEPROM MODIFICATION
NOTE: For this modification it is necessary to use an EEPROM programmer.
We recommend our SEP-EECLIP.
•First, set the programmer reading in 8 bit hexadecimal (HEX).
• Desolder and make a backup of the 24C16 EEPROM (shown in picture 4)
• To reach a voltage close to 12.00V act on 02D8 location
Please note that decreasing this location by 1 HEX unit, the variation will be + 0.016V, or vice versa.
NOTE: For the oflline version download PDF.
If not familiar with hexadecimal calculation, it is possibile to use the calculation tool in the box below, simply typing in the values.
Once these modifications have been done, measure again the voltage between A and B points and check that it actually is between 11.98V and 12.02V. If not, increase or decrease the location until the value is as close as possible to the right range.